Masonry Technology Logo

10mm Control Cavity™

CC4810
10mm Control Cavity Images

What 10mm Control Cavity does:

  • It’s a cavity weep system.
  • It separates wood framing, insulation and sheetrock from concrete or masonry walls.
  • It’s easy to install (Roll, 25' x 31.5" Wide — weight, 35 lbs).

How to install 10mm Control Cavity*

  • Install with channel pattern running up & down(vertically).
  • Overlap all edges and ends a minimum of 1".
  • Overlap horizontal edges shingle fashion to outside concrete,masonry substrate (see lap detail drawing) — upper sheet laps behind (back-laps) lower sheet.
  • Cover entire wall surface, top to bottom, in this fashion.
  • Mechanically fasten Control Cavity with concrete nails or power fastener.
  • Fastening pattern to be 2' on center.

Ordering and Shipping Information

Product Number CC 4810
Roll Length (feet) 25
Roll Width (inches) 31½
Square Feet per Roll 66
Rolls per Box NA
Rolls per Pallet 32
Square Feet per Pallet 2112
Pallet Size 48" x 48" x 68"

Contact MTI at 1-800-879-3348 for specific cost to your destination.

10mm Control Cavity Specifications

Made of Recycleable Materials0.020" (0.65 mm) thick by 31 1/2" (800mm) wide high-impact polystyrene sheet formed with 10mm deep corrugations.

Note 1: Masonry Technology Inc. recommends that all sump baskets, drain tile, and drain field systems be vented. If sump baskets, drain tile, and drain field systems are not vented, MTI recommends that top edge of Floor Edging™ be caulked or sealed off with appropriate material.

Note 2: Control Cavity™ shall not be used as a finished wall surface. Control Cavity™ should be covered with appropriate furring, insulation and finished interior wall materials.

Note 3: When an in-floor heating system is installed, a vented interior drain field and drain system must be installed to release under slab pressure.

*Caution - COMBUSTIBLE: Protect from open flame and/or other items producing high heat. Use MTI materials in strict conformance with local building codes and regulations. Consult with local code or building official prior to installation. It is the buyer’s responsibility to en-sure that MTI materials are used in strict conformance with local building codes and regulations.

Product Cutsheet: Download Product Cut Sheet

Google SketchUp 3D Model: Download Product Model from 3D Warehouse



Popular HyperSpecs® Wall Details featuring 10mm Control Cavity
Browse Wall Details | Browse Wall Details with 10mm Control Cavity


*The installation listed provides the most common installation instructions. For specific installation details please find your wall detail in our HyperSpecs library.